How to connect your Netgear Extender using WPS
How to connect your Netgear Extender using WPS
In this document we will know how to connect your Netgear Extender using WPS
Call @: 1-844-663-3333

How to connect your Netgear Extender using WPS

In order to use wps method for the configuration of your Netgear Extender you need to go through following steps.

  • Power on your Netgear Extender and make sure you have one solid green light on it for power.
  • Your Netgear Extender should be in the same room where your router is. it should be as close as possible.
  • Make sure you have internet access on your router.
  • Firstly You should have to press the wps button on your Netgear Extender.After that you should do press the wps button on your router within 2 minutes .
  • wait for the other solid green lights to show up on your Netgear Extender.
  •  

    Now once you have all other lights on your Extender check for any firmware update on your extender if available then update it and move it to the place where you want it to be.

     

    Related Article:-
    How to connect your netgear extender using mywifiext.net
    How to Setup Netgear Wifi Range Exender
    How to setup your Netgear Extender as an Access Point
    How to connect Netgear wireless range extender using Ethernet cable
    <