How to connect your netgear extender using mywifiext.net
Firstly one should keep in mind that www.mywifiext.net is a local web addresses for configuration of Netgear extender and not a website. In order to configure Netgear Extender using WWW.MYWIFIEXT.NET one need to go through series of steps which are as given below.
Firstly power on Netgear Extender and make sure you have one solid light for power on it.
Now make sure you have internet access on your home router.
Grab any wireless device such as laptop, tablet, i-phone etc.
Now connect your device to your Netgear Extender Network.
It will directly take you to NEW EXTENDER SETUP page, if not then open your browser on your device and on the address bar type “WWW.MYWIFIEXT.NET” or “192.168.1.250” which will take you to NEW EXTENDER SETUP page.
Now click the Setup button and it will scan for the available networks around you. Select your home network and then hit continue button down below.
It will ask you for your home network password do punch that and hit continue.
Now it will show you page with your extended network if you want to change the name of your extender you can change it over here or else hit continue.
Now it will apply the settings to your extender and once done will ask you to connect your devices to the new network available.
Do check on your extender if there is any firmware update available. If yes, then update it from the setup page itself.
And from here your extender will be good to go. You can move it all around your home for the best place to place it, from where it will extend your regular wifi signal and will cover all your dead zones.