does not work does not work doesn’t work, and getting problem in using internet. does not work

Are you unable to access the You can try alternative option through IP Address in the place of when you try to connect netgear wireless range extender to your router via an Ethernet cable. Your Extender must be plugged in power and it will show green light. does not work. What should I do to fix it out?

If does not work, then this pertains to a serious issue with your network. is a local webpage which performs multiple functions with regards to your NETGEAR WiFi extender devices.

This webpage works as an interface through which user can interact with NETGEAR range extender device.

You will need webpage both for launching your new extender setup, as well as to alter the configuration of already installed network.

Launching new extender setup includes two steps. That are:

  1. Powering on NETGEAR extender.
  2. Establishing connection between range extender and home router.

At this second step comes to the role of this local webpage. Although NETGEAR provides two ways of installation of the extender, it is in the only manual method that we require webpage to establish the connection between range extender and home network.

Now comes question how to establish this connection using webpage. For this you have to follow the steps as mentioned below:

  • Before moving for the second step of new extender setup, i.e. establishing a link between range extender and home network, you have to complete the first step which is to power on your range extender device.
  • Reason for it is that time up to which device will not be in up-state you will be unable to access it.
  • Once your device gets powered on arranging a network device such as a computer or tablet. Establish a link between your range extender and the network device which for the time being we are considering to be a computer, by using Ethernet cable.
  • If in case, you are using a NETGEAR range extender that does not have an Ethernet port then you can use Wi-Fi signal for establishing this link.
  • Next step includes opening a web browser on your device. webpage will get opened on its own. But if it does not, then you will be required to enter in the address bar of your browser.
  • By entering default credentials you will become able to start setup wizard.
  • Here click on New extender setup button.
  • By following instructions as mentioned on your screen your installation of new NETGEAR range extender using this local webpage will be completed.

Now comes the main question that is what to do if does not work.

There can be the number of reason because of which does not work. But need not to worry. In this article, we will provide you with some troubleshooting steps for the same.

In most of the cases it has been found that by taking these troubleshooting steps users became able to access this local webpage. But if in case your issue does not get resolved by it then you can contact on NETGEAR support and can get technical support via phone call.

Let’s start discussion on these troubleshooting steps:

  • If does not work during the installation process of the extender, then this can be due to a loose Ethernet connection. Try to establish a connection by using another Ethernet cable.
  • Another reason may be because of difference in subnet mask of your client device which you are using for installing NETGEAR extender. In that scenario, you are required to assign the static IP address to your client device. And then try to re-launch this local webpage.
  • Another reason can also be firmware updation. There are chances that you may have missed out firmware updation notification, which is now hindering you from accessing the web interface.
    Now comes question how to update the firmware because even for firmware updation you do need to log in this local webpage.

We hope by this you will become able to access webpage.


Related Article:-
Know about
Can not access
Common issues during connecting Netgear Extender